After choosing the Twinbadge in Eventure, you can choose ‘change badge design’. This brings you into a screen similar to the screen shown below.
To have the same fields on the back of the twinbadge copy (CTRL-C), paste (CTRL-V) and move them to the right. If you want other information on the back of the twinbage, like events (module ‘Events on badge’ is required), addresses, etc, use the ‘Field Tool’ soft key. Use the ‘Text Tool’ soft key to add text on the badge.
Tip: Use the arrow keys to move the selected fields in a straight line or move them a little bit.
These are the margins from the left side of each badge. See Illustration.
Badge front Badge back
- Object coordinates 54 Object coordinates 422
- Centimeters 1,429 Centimeters 11,351
- Inches 0,563 Inches 4,469
These are the upper and lower margin of the twinbage.
Upper margin Lower margin
- Object coordinates 765 Object coordinates 1027
- Centimeters 20,241 Centimeters 27,173
- Inches 7,969 Inches 10,698
Here is an example of a twinbadge with Logo and a summary of events on the back.
The Parthen TwinBadge 1070 uses only the lower part of the paper. The upper part can be used for different reasons i.e. A letter for the participant with information about the conference. See the example below.